1:18 Ferrari decal for BBR Enzo

[CCX]

Is it possible to buy a replacement decal for the rear of a 1:18 Enzo? I'm after the silver script on the engine cover, by the rear wing (it got caught on a cloth, a mistake I'll never make again!). If anyone knows where to get one that would be much appreciated.

[[KRAFTIG]]

Hi, yes you. I've lost a few over the years and replaced with these. Installation is a bit tricky at times, but there are extras if you mess up

http://www.ebay.ca/itm/1-18-1-12-1-24-1 ... 27f7bb9db3

[CCX]

That's a huge help, thanks a lot. I'll buy some and see how I get on.

[[KRAFTIG]]

I'm glad I could help

[oiseaulo]

out of curiousity, how does it work?

[[KRAFTIG]]

Very simple!

https://www.youtube.com/watch?v=HimjzzDmEJI

[Gavin]

that works for waterslides...the ones in your link are metal.

According to the auction listing:

Instruction on how to apply metal transfer:

1.Cut the metal transfer from sheet using scissor or knife

2.Remove the white color base paper,maintain the protective clear paper

3.Stick the metal transfer on surface required.Press it down,then remove the protective clear paper from surface