This is a beautiful model! I love the gator top.
I read on other forums that the low rear suspension.
For the following I corrected him by:
Sorry, I bad English. Google translator to my help
So I lifted the rear part
I took it apart the body and chassis. 6 screws on the bottom. The nose of the apron panel and a stern plate under the bumper have to choose carefully!
You need two pieces snapped leaf spring:
Will look at two of the fixing of the rear suspension with coil springs.
These models provide cushioning. Only the screws completely to the frame being clamped. Thus, they can not move, and the stern sat down model.
Here is one screw. The other is already uninstalled:
The indicated (arrow) bore should move the rear axle:
The screws must be loosened and adjusted the height of the rump.
Fully screwed in the screw, the wheel drum approx. 3 mm in length, in the wheel:
I have approx. 6-7 mm between active.
It will not be possible because the screws will not hold:
The result before and after:
In the end it has to be mounted on the chassis and body of the leaf springs back together. You might even then have to set the height, the rear end of the leaf springs do not go into the hole. I hope has worked well, and the Google translator to understand my writing was...